NordicTrack NTEL79010 user manual Installing the Receiver for the Optional Chest Pulse Sensor

8.Apply a small amount of the included Teflon® lubricant to a paper towel. Rub a thin film of the lubricant onto the Chrome Tubes (21) on the Left and Right Spring Arms (3, 4). Next, slide the Left Upper Body Arm (7), which is marked with a sticker, onto the Chrome Tube on the Left Spring Arm. Slide the Right Upper Body Arm (75) onto the Chrome Tube on the Right Spring Arm. Make sure that the Upper Body Arms are on the correct sides—the upper ends should bend in the direction shown by the arrows. Next, slide an Axle Cover (74) onto the post on each Upper Body Arm.

Apply grease to the Arm Axle (19). Insert the Arm Axle into the right Axle Cover (74) and the Right Upper Body Arm (75). Next, insert the Arm Axle into the Upright (2) until the left end of the Arm Axle is flush with the left side of the Upright. Then, insert the Arm Axle into the left Axle Cover (74) and the Left Upper Body Arm (7).

Center the Arm Axle (19). Using the included pedal tool, tap two Push Nuts (15) about 1/8” onto each end of the Arm Axle. Make sure that the Push Nuts are turned as shown in the inset drawing. (Note: It may be helpful if another person holds a block of wood against one end of the Arm Axle while you tap Push Nuts onto the other end.) Then, press an Axle Cap (34) onto each end of the Arm Axle.

8				75
				74
			19	34
				15
			74
7				2
			Grease
			Post
34	15			21
				4
				21
				3
Pedal Tool		15	19

9.Make sure that all parts of the elliptical crosstrainer are properly tightened. Note: Some hardware may be left over after assembly is completed.

INSTALLING THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSOR

If you purchase the optional chest pulse sensor (refer to page 20), follow the steps below to install the receiver and the short jumper wire included with the chest pulse sensor.

1.Remove the four indicated screws from the back of the Console (87). Lift off the front of the Console.

1

Screws

87

2. Peel the paper off the adhesive pad on the back of the	2
receiver (A). Orient the receiver exactly as shown, and
		B
press it onto the Console (87) in the indicated location.
Connect the short jumper wire (B) to the wire on the
receiver (A). Plug the other end of the short jumper wire		87
into either of the indicated jacks on the Console (87).
Note: The included long jumper wire is not needed.	Jacks
		A
Refer to step 1 above. Reattach the front of the
Console (87) with the four screws. Make sure that no		Cylinder
wires are pinched.

8