5.With the help of a second person, set the con- sole assembly on the Uprights (85). Make sure that no wires are pinched. Attach the console assembly with four Console Bolts (72) and four Star Washers (67). Start all four Console Bolts before tightening any of them.
6.Remove the knob from the pin. Make sure that the collar and the spring are on the pin.
Press the Latch Insert (77) into the right side of the left Upright (85), and press the Knob Insert (92) into the left side of the left Upright. Use a rubber mallet, if necessary. Next, insert the pin into the Latch Insert, and tighten the knob back onto the pin.
5 | Console |
| |
| Assembly |
67 | 67 |
72 | 72 |
85 | 85 |
6 |
|
Knob 
77
92Spring
Collar
85 | Pin |
7.Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 23). To protect the floor or carpet from damage, place a mat under the treadmill.
If you purchase the optional chest pulse sensor (see page 19), follow the steps below to install the re- ceiver included with the chest pulse sensor.
1.Make sure that the power cord is unplugged. Remove the indicated Screw (7) and the Access Door (95) from the left side of the Console Base (98).
2.Connect the wire on the receiver (A) to the indi- cated wire extending from the Console Base
(98). Hold the receiver so the small cylinder is oriented as shown and is facing the Console Base. Attach the receiver to the plastic posts on the Access Door (95) with the two included small screws.
3.Make sure that no wires are pinched. Reattach the Access Door (95) with the Screw
(7). Discard the other wires included with the re- ceiver.
98 | Wire |
| |
| Small |
| Screws |
95 |
|
| A |
| Small |
7 | Cylinder |
8 |
|