PBFS0t EXS00 BASE UNIT ASSEMBLY INSTRUCTIONS (S~fEP #3)
THE INSTRUCTIONSFOR STEP #,'3 ARE TO BE USED WITH DRAWINGSHLET #4 OF 6.
'3.
7.
Place each of the two (2) WEIGHTSTACKBUMPERSover the GUIDERODHOLES(RADIUS EDGESFACINGUP) on the WEIGHTSTACKSUPPORTBASE. Insert each of the two (2) GUIDE RODSthrough the WEIGHTSTACKBUMPERSand into the WEIGHTSTACKSUPPOP.T BASE.
(NOTE:Apply thin film of LUBRICATION(PROVIDED)to guide rods by using paper towel or clean hands.)
Press two (2) WEIGHTPLATEBUSHINGSeach, into the top of tv~.enty (20) WEIGH'FPLATES
BUSHINGStotal, SEE DETAILF). | : |
|
_USINGEXTREMECARE, slide each of the twenty (20) WEIGHTPLATESdown over the GUIDE RODS onto the WEIGHTSTACK SUPPORT BASE. (BE SURE THE KEY HOLE OF THE WEIGHTPLATES ARE FACING THE FRONT OF TIIE MACIL1NE) (SEE DtL4.,WING)
Securely assemble the WEIGHTSTACKSHAFTinto fire IIEAD PLATE,using one (I) 3/8 X
Slide HEAD PLATE ASSEMBLY down over GUIDE RODS o~i'o WEIGHT STACK.
Place the WEIGHTSELECTPIN into any WEIGHTPLATEby turning and pushing :it to engage the
WEIGHT PLATE.
Slide two (2)
Dt~TALLE)......
8.Insert the four' (4) 3/8 IN. DIA. GUIDERODINSULATORS(two per GUIDEROD)into the GUIDE
ROD. Position GUIDE RODS:~n FRONT ofthe GUIDE ROD BRACKET on the TOP BOOM
CAUTION: DO NOT OVER TIGHTEN GUIDE RODS TO THE FRONT SiDE OF THE 'FOP BOOM SECTION. OVER TIGHTENING MAY C.~.USE
JJ
NOTE:
Slide 13/16 IN. SHAFTCOLLAR.Sand
of TOP BOOM SECTION.TightenALLENSCRFWSin the COLLARSto secureto GUIDERODS.
These COLLARSare provided for the purpose of preventing the WEIGHTSTACKSHAF'r from brealdng the TOPPULLEYMake. sure the
10.,~¢ Attach the WEIGHTSTACKLABELS(designated from #l to #20) to the WEIGHTSTACKPLATES
(SEE DETAIL 19
II