PBFb01 EXb00 BASE UNIT ASSEMBLY INSTRUCTIONS #!)
o
Insert one (1) 2 IN. SQ. ENDCAPinto the BASESEATSUPPORTand carefully place it on its side the floor.
, "~~,8X 1-
Loosely assemble the BASESEATSUPPORTto the MAINBACKSUPPORT,using two (2) 1/4 BOLTS,four (4) 378 WASHERS,two (2) 3/8 LOCKWASHERS,and two (2) 3/8
Insert a 2 IN. SQ. ENDCAPinto the opert end office EASETEESECTION.
Loosely assemble the BASETEE SECTIONto the MAINBACKSUPPORTASSE~CEBLY(from step
#7),at thefollowingtwocormect~onpoints:ENDCONNECTION~one- (I)I~ x 5 BC~LT,two(2)
WASHERS,one (I) 1/2 LOCKWASHER,and one (1) 1/2 NUT; and the INSIDE CONNECTION:
(I)I/2 x 7 BOLT,two (2) 1/2 WASHERS,one (I) 1/2 LOCKWASIIER,and one C[) IP-
10.Carefully stand the MAINBACKSUPPORTASSEMBLY(from previous step) in its upright position and slide it into position to connect with the WEIGHTSTACKSUPPORTBASE.Loosely assemble this connection using, two (2) 1/2 X
and two (2) 112 NUTS.
11.Loosely assemble the REARLEFT UPRIGHT(NOTE: THIS UPRIGHTHAS FIVE (5) HOLES THROUGHIT) and the REARRIGHTUPRIGHTto their respective sides at the TOP and BOTTOM CONNECTIONPOINTS as follows:
At the TOP CONNECTIONPOINT, loosely assembling to the TOP BOOIV[SECTION,use one (1) 1/2 x
(1)318 LOCI(WASHERS,and one (1) 3/8 NUTon the inside bolt connection. NOTE:ONE
318 DIA. x 2 LG.
At the BOTTOMCONNECTIONPOINT, loosely assembling to the CONNECTORFLATS on the WEIGHTSTACI~SUPPORTBASE, use two (2) I/2 x 3 BOLTS,fo,~r (4)
PLACE REAR RIGHT AND LEFT UPRIGHTS ON THE CORRECT SIDES OF THE ¯ CONNECTORFLATS on the WEIGHT STACK SUPPORT BASE.
12.Securely mount the BACKPADto the MAINBACKSUPPORTusing, two (2) 3/8 x
(2)318 LOCKWASHERS,and two (2) 3/8 WASHERS.BE SURE TO POSITION THE PAD THAT THE METAL HIDEM WELT CLIP IS POSITIONED IN THE DOWNPOSITION.