PBFS01 EXS00 BASE U-NIT ASSEMBLY INSTRUCTIONS(~,TEP #2)
24.Attacheight(8) PARAGLIDESTRIPSto the ADJUSTABLESEAT FRAMEand the :BASESEAT SUPPORTas shownin DETAIL andB onthereversesideof themainassemblydrawingforSTEP
#2, (SHEET#3 of 6), using the following steps:
A.Thoroughlyclean all inside and outside surfaces wherethe paraglide strips sre ::o be attached.
B.Removethe paper backing
.-
25.Attach the SEATPADto the ADJUSTABLESEATFRAME,using two (2) 3/8 x 3 BOLTS,two (2) LOCII WASHERS,and two (2) 3/8 WASHERSBE. SURETO POSITIONTHE PA]) SO
26.Place the ADJUSTABLESEATFRAMEASSEMBLYinto the slide receptacle on the BASESEAT SUPPORT,disengaging the SPRINGPIN ASSEMBLYuntil the plunger engages flue first adjustment hole.
27.Install one (1) thumbscrew into the BASESEATSUPPORT.
28.Attach the PRESS ARMto the TOP BOOMSECTION, by sliding the PRESS ARMBEARING SHAFTthrough the PRESSARMand the TOPBOOMSECTIONuntil it is flush with both sides. Securely tighten two (2) 5/16 SETSCREWS(using a 5/32 inch hex key) through the collars on
PRESS ARMinto the PRESS ARMSUPPORTSHAFT. NOTE: POSITION PRESS ARNI SO
29.Install the two (2) 3/8 DIA. X2 IN. BUSHINGPULLEYSbetween the fiats on the PIq2ESSAP~M,using two (2) 3/8 x 3 BOLTS,four (4) 3/8 WASHERS,two (2) 3/8 LOCK
30.Attach two (2) 5 IN. GRIPSand two (2) 7 IN. GRIPSonto the straight and angled P]LE.~S HANDLES,NOTE:If a lubricant is required, RUBBINGALCOHOLthoroughly coating the inside
"of the grip is the best material to use.