FIGURE 18 | 3/8 X 4-1/4” | 68 |
| | | 51 37 |
| | 8 | 71 |
| | |
3/8 X 3” | 67 | | 69 |
| | | 11 |
| | | 2 |
3/8 X 3-3/4” | 57 | 49 | |
| | 63 |
| | |
| 64 | | |
| 37 | | |
| | 30 | 63 |
| | |
STEP 18:
•Securely assemble the ball end of the LEG CABLE (30) and one 3-1/2” PULLEY (37) to the LEG PEDESTAL (8) using two 3/8 X 3-3/4” BOLTS (57), two 3/8” X 1-1/16” FLANGE SPACERS (49), two 3/8” WASHERS (64), and two 3/8” LOCKNUTS (63).
(NOTE: The LEG CABLE (91) must be routed over the retaining bolt as shown in FIGURE 18.)
•Securely assemble one 3-1/2” PULLEY (37) to the UPRIGHT (2) using one 3/8 X 3” BOLT (67) and one 3/8” LOCKNUT (63).
(NOTE: The LEG CABLE (91) must be routed over the retaining bolt as shown in FIGURE 18.)
•Assemble one 3-1/2” PULLEY (37) to the BASE PLATES (11) using one 3/8 X 4-1/4” BOLT (68), two 3/8” SAE WASHERS (69), two GUIDE CABLES (71), two 3/8 X 1” SPACERS (51) and one 3/8” LOCK NUT (63). See FIGURE 18.(Note: Loop the LEG
CABLE (30) around the PULLEY prior to assembling the PULLEY to the BASE PLATES.)
17
