ParaBody 950102 manual 318

Page 12

STEP 9-B

~

STEP 9-A

STEP g

Slide two hinge tabs; (73) onto the leg frame (14) and securely attach leg scat pad (4T) using

A.3/8 x I" bolls (97), and two 5/B" washers (TB). (Nole: The "hinge" part of the hinge tab should face downward.)

B.Atiach$wo rollerp.a, ds (19) to the leg frame(14) u(s;;~asoneshown16-3/~".rollerpad shaft,',27),

plastic washers (55,1 and two 3/4" starlock, collars

318 X

SEE NOTE

3/B x %" ]~TTN

frame (14) using

STEP 10

Attach leg back pad adust (11), and leg back pad support (12) to the

A.one 1/2 x S-l/?-" bolt (92), two 1/2" flange bearings (69) and one 1/2" low height lock nut as shown. (Note: Securely tighten, then back nut off 1/4 turn to allow the two pa~'ts to'

rotate ireely.)

B.Securely attach fl~e leg back pad (48) to the leg back pod adiust (11), and leg back

to Jh eg frame 14) using .two ~/

ack lock she~s ~86), one two 3/~

(66), one 3/£' tapped axle (76), bu~on head cop screws

~E= ~ ~'P ~RE~S ~T~ ~~ AT THE S~E T~ ~ ~ ALLEN

Securely aflach rubber bumper (56) between con~act point of leg curl/extension (B) and

D.

frame ~14) a~ s;hown.

Image 12
Contents SeriousSteel ~ ~o~ ~ two ~N~ ONF~ 91 3102943 BOLT,i/Z-13X~1/2 Frame Assembly Instructions Step 314 Tw~,bol~.11z Step Step 318 ~1/2 X 318 Page Assemble one selector Step Cable Guide Step F & H Step Step Step X ~-~/~~o=~~ss. ~.~ ~/s ~.g~ =p~=~7~, ~ o~ ~/s ~o=kn=~ S~ Page Ie~ ~uiderodsunno~25 ~innon~~/~.x 2-$/~bolt Shroud Assembly Instructions THIS. Concludestheassemblyof the PARABODY950 ST GYM