ParaBody 950102 manual Step

Page 9

Step 6

A.SlTde two hinge tabs (73) onto two 3/8 x 1" bolf;~ (97), and

should face upward.)

the wolff sleeve (39) and securely attach press seat pl:ld (49) two 3/8" washers (78). (Note: The "hinge" part of the hinge

'B. Slide the right back pad angle (2) and left back pad angle (5) onto the wolff sleeve (39) attach the press back pad (50) using four 3/8 x 1" bolts (97), and four 3/B" wash=:rs

C.Secure the 1/2 x 2 x 15-1/2" using two 1/2 x 1l-1/4~' bolts.

Secure nuts, then back off 1/4

D.Secure the 1/2 x 2 x 15-1/2" bolt (94) and one 1/2" nylock

E.Apply one rubber Ibumber (56) contact with the rear bolt.

plate (116) to right back pad angle (2) and the left back pad angle (87), two 1/2" washers (79), and two 1/2" low heigh! nyIock

.turn.)

plate (116) fo bushing in press base (15) using 1/2 x 6- 1/ 2" nut (82). Secure nut, then back off 1/4 turn.

to the back of the press back pad (50) where the .pa=~ comes

10

Image 9
Contents SeriousSteel ~ ~o~ ~ two ~N~ ONF~ 91 3102943 BOLT,i/Z-13X~1/2 Frame Assembly Instructions Step 314 Tw~,bol~.11z Step Step 318 ~1/2 X 318 Page Assemble one selector Step Cable Guide Step F & H Step Step Step X ~-~/~~o=~~ss. ~.~ ~/s ~.g~ =p~=~7~, ~ o~ ~/s ~o=kn=~ S~ Page Ie~ ~uiderodsunno~25 ~innon~~/~.x 2-$/~bolt Shroud Assembly Instructions THIS. Concludestheassemblyof the PARABODY950 ST GYM