Leftpressarm Handle Q to rotate freely | ParaBody GS6 specification

	I
	Q
AO	27
R
	FIGURE 24

STEP 24:

•Assemble the RIGHT PRESS ARM HANDLE (R) to the PRESS ARM (I) using one 25/32” BUMPER (AO) and one 1/2” LOW HEIGHT LOCK NUT (27) as shown in FIGURE 24. (NOTE: Tighten 1/2” LOW HEIGHT LOCK NUT (27) to remove excess play yet allow the

RIGHTPRESSARM HANDLE (R) to rotate freely.)

•Assemble the LEFT PRESS ARM HANDLE (Q) to the PRESS ARM (I) using one 25/32” BUMPER (AO) and one 1/2” LOW HEIGHT LOCK NUT (27) as shown in FIGURE 24. (NOTE: Tighten 1/2” LOW HEIGHT LOCK NUT (27) to remove excess play yet allow the

LEFTPRESSARM HANDLE (Q) to rotate freely.)

G
AH	I
	I
	AH
	PUSH-PULL
	CABLE
	FIGURE 25

STEP 25:

•SECURELY assemble the SPRING PINASSEMBLY of the PUSH/PULL CABLE to the spring pin barrel on the PRESS ARM ADJUST-

MENTTUBE (AH). (!!!IMPORTANT!!!TIGHTENTHENUTOFTHESPRINGPINASSEMBLYSECURELY)

•Swing the PRESS ARM (I) up until the SPRING PIN of the PUSH/PULL CABLE engages in one of the adjustment holes on the PRESS ARMADJUSMENT (G).