ParaBody GS6 manual Pulley prior to assembling the Pulley to the Base

(a)
28					28
52 3/8 X 2-1/4”
31
49
C
		C
	AE	28		49	32
(b)			C
			52 3/8 X 2-1/4”
	23		49		17 3/8 X 1-3/4”
		33
3/8 X 3-1/2” 12	A				51
3/8 X 3” 14					49
					C
					F
					28
					(c)
					15 3/8 X 2-3/4”
FIGURE 29

STEP 29:

•Assemble one 3-1/2” PULLEY (49) to the bracket on the BASE (A) using one 3/8 X 2-1/4” BOLT (52),one 3-1/2” PULLEY GUARD (C), one 3/8” SPACER (31) and one 3/8” LOCK NUT (28). See FIGURE 29(a) (Note: Loop the LOW CABLE (45) around the

PULLEY prior to assembling the PULLEY to the BASE .)

•Assemble one 3-1/2” PULLEY (49) to the tube on the BASE (A) using one 3/8 X 3” BOLT (14), one 3/8 WASHER (23) one 3-1/2” PULLEY GUARD (C), one 13/32“ SPACER (33) and one 3/8” LOCK NUT (28). See FIGURE 29(b) (Note: Loop the LOW CABLE (AW) around the PULLEYprior to assembling the PULLEYto the BASE .)

•Assemble one 3-1/2” PULLEY (49) to the PRESS LOAD ARM (AE) using one 3/8 X 3-1/2” BOLT (12), one 3/8 WASHER (23)

one 3-1/2” PULLEY GUARD (C) and one 3/8” LOCK NUT (28). See FIGURE 29(b) (Note: Loop the LOW CABLE (AW) around the

PULLEYprior to assembling the PULLEYto the PRESS LOADARM .)

•Assemble one 3-1/2” PULLEY (49) and one 3-1/2” PULLEY GUARD (C) to the BASE (B) using one 3/8 X 2-1/4” BOLT (52), one 3/8 X 7/16” SPACER (33) and one 3/8” LOCK NUT (28). See FIGURE 29. (Note: Loop the LOW CABLE (AW) around the PULLEYprior to assembling the PULLEY to the BASE.)

•Route the LOW CABLE (AW) around one 3-1/2” PULLEY (49) and assemble to the horizontal bracket on the FOOT FRAME (F) using one 3/8 X 1-3/4” BOLT (17), one 3-1/2” PULLEY GUARD (C) and one 3/8” LOCK NUT (28). See FIGURE 29(c)

•Route the LOW CABLE (AW) under one 4-1/2” V-GROOVE PULLEY(51) and assemble the 4-1/2” V-GROOVE PULLEY(50) to the vertical bracket on the FOOT FRAME (F) using 3/8 X 2-3/4” BOLT (15) and one 3/8” LOCK NUT (28). See FIGURE 29(c)

27