ParaBody 877102 manual LOW Height

Page 11

22

18

1/2 X 3”

27

 

 

12

7

 

 

 

 

 

 

 

 

11

 

26

 

 

 

8

 

 

 

 

23

LOW HEIGHT 24

 

 

 

32

 

 

 

 

 

 

FIGURE 8

STEP 8:

Insert three 1-3/4” SQ. END CAPS (23) into the ends of the LEG EXTENSION (8) as shown in FIGURE 8.

Insert two 1/2” FLANGE BEARINGS (26) into the BUSHING on the LEG EXTENSION (8) as shown in FIGURE 8.

Assemble the LEG EXTENSION (8) to the LEG EXTENSION NECK (7) as shown in FIGURE 8, using one 1/2 X 3” BOLT (18), two 1/2” WASHERS (22), and one 1/2” LOW HEIGHT LOCK NUT (24). (TIGHTEN THE CONNECTION ENOUGH

TO REMOVE THE PLAY, YET ALLOWING THE LEG EXTENSION TO ROTATE FREELY)

Assemble four ROLLER PADS (12) to the LEG EXTENSION (8) as shown in FIGURE 8, using two ROLLER PAD SHAFTS (11), and four 3/4” STARLOCK COLLARS (27).

Attach one 3/4” SQ. RUBBER BUMPER (32) to the LEG EXTENSION (8) approximately where shown in FIGURE 8.

11

Image 11
Contents Bodysmith Narrow Workout Center Assembly Instructions Important Notes Parts List Step On the Base LEG is Under the Bench Frame X 2-3/4 Inside of the Grip with Rubbing Alcohol Sure Both Hinge Tabs are ALL the WAY on the PIN Step Step LOW Height Step Step