ParaBody 877102 manual Inside of the Grip with Rubbing Alcohol

Page 7

30

 

 

6

 

31

29

31

 

1

FIGURE 4

 

STEP 4:

Attach eight PARAGLIDE STRIPS (31) to both UPRIGHT TUBES on the UPRIGHT FRAME (1) (FOUR ON EACH END) as shown in FIGURE 4 using the following steps:

Thoroughly clean all surfaces where the PARAGLIDE STRIPS are to be attached.

Remove the PARAGLIDE STRIPS from the paper backing and firmly apply them to all shown surfaces.

Attach eight PARAGLIDE STRIPS (31) to each SADDLE (6) (FOUR ON EACH END) as shown in FIGURE 4.

Slide two 1-1/4 X 5” GRIPS (30) over the DIP HANDLES of both SADDLES (6). (IF A LUBRICANT IS REQUIRED, COAT

THE INSIDE OF THE GRIP WITH RUBBING ALCOHOL.)

Pull back the SPRING PIN on the UPRIGHT TUBES, and insert the SADDLES (6) as shown in FIGURE 4.. Slide the SADDLE

(6)down to the desired height and release the SPRING PIN into the hole.

Secure the SADDLES (6) in place with two THUMBSCREWS (29) as shown in FIGURE 4. When ready to perform the DIP EXERCISE, simply insert the SADDLES (6) into the UPRIGHT TUBES and tighten the two THUMBSCREWS

7

Image 7
Contents Bodysmith Narrow Workout Center Assembly Instructions Important Notes Parts List Step On the Base LEG is Under the Bench Frame X 2-3/4 Inside of the Grip with Rubbing Alcohol Sure Both Hinge Tabs are ALL the WAY on the PIN Step Step LOW Height Step Step