ParaBody 877102 manual Step

Page 4

 

28

 

4

 

25

10

31

 

FIGURE 1

 

STEP 1:

•Attach eight PARAGLIDE STRIPS (31) to the WOLFF SLEEVE (4) (FOUR ON EACH END) as shown in FIGURE 1 using the following steps:

•Thoroughly clean all surfaces where the PARAGLIDE STRIPS are to be attached.

•Remove the PARAGLIDE STRIPS from the paper backing and firmly apply them to all shown surfaces.

•Insert one U-PIN (10) through the BUSHING of the WOLFF SLEEVE (4) and attach one PAL NUT (28) to the end of the U-PIN (10) as shown in FIGURE 1.

•SECURELY assemble one 3/8” SPRING PIN ASSEMBLY (25) to the SPRING PIN HOUSING on the WOLFF SLEEVE (4) as shown in FIGURE 1. (!!! IMPORTANT !!! TIGHTEN THE NUT OF THE SPRING PIN ASSEMBLY SECURELY)

 

1/2

 

1/2

 

1/2

 

1/2

 

1/2

 

 

1/2

0

1

2

3

4

5

6

4

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Bodysmith Narrow Workout Center Assembly Instructions Important Notes Parts List Step On the Base LEG is Under the Bench Frame X 2-3/4 Inside of the Grip with Rubbing Alcohol Sure Both Hinge Tabs are ALL the WAY on the PIN Step Step LOW Height Step Step
Top Page Image Contents