Spring PIN Adjustment

FIGURE 14

STEP 14

•The 100 LEG PRESS is equipped with a spring pin adjustment to accommodate different sized users and allow easy entry and exit from the machine. To use, you must slightly push against the foot plates to take tension off the pin.

•To set the correct amount of tension in the cables, adjust the 100 LEG PRESS into the last adjustment hole (so the LEG PRESS is spread apart) and remove the WEIGHT STACK PIN. Thread the 110-3/4” CABLE (16) into the HEAD PLATE ASSEMBLY until the PULLEY BRACKET (2) is held against the TOP BOOM and the cable is slightly pulling up on the HEAD PLATE. Tighten the jan but securely. Next, thread the 82-1/2” CABLE (17) into the PULLEY BRACKET (2) until cable is tight , then tighten the jam nut securely.

Thank you for purchasing the Parabody 441101 LEG PRESS ADAPTER KIT. If unsure of proper use of equipment, call your local Parabody distributor or call the Parabody customer service department at (800)

328-9714.

	1/2		1/2		1/2		1/2		1/2		1/2
0		1		2		3		4		5		6