Jonsered CS 2145 Adjustment of the oil pump, Centrifugal cleaning, Cooling system, Winter use

MAINTENANCE

Adjustment of the oil pump

Centrifugal cleaning

The oil pump is adjustable. Adjustments are made by turning the screw using a screwdriver or combination spanner. The saw is supplied from the factory with the screw set to position 2. Turning the screw clockwise will reduce the oil flow and turning the screw anti-clockwise will increase the oil flow.

	+	–
2	1
3

Centrifugal cleaning means the following:

All air to the carburetor is carried through the starter. Dirt and dust is centrifuged away by the cooling fan.

IMPORTANT! In order to keep the function of the centrifugal cleaning, a continous maintenance and care must be made.

!WARNING! The engine must not be running when making adjustments.

Recommended settings:

Bar 13"-15": Position 1

Bar 15"-18": Position 2

Bar 18"-20": Position 3

Cooling system

To obtain the lowest possible running temperature the saw is equipped with a cooling system.

•Clean the air intake to the starter, the fan wings of the flywheel, the space around the flywheel, inlet pipe and carburetor space.

Winter use

During winter time, snow and cold weather can cause running problems, such as:

•Too low engine temperature.

•Icing of the air filter and freezing of the carburetor.

Therefore some special measures are required:

•Partly reduce the air inlet of the starter and by doing that increase the engine temperature.

•Preheat the intake air to the carburetor by using the heat from the cylinder.

The cooling system consists of:

1.Air intake on the starter unit.

2.Air guide plate.

3.Fan blades on the flywheel.

4.Cooling fins on the cylinder.

5.Cylinder cowling (supplies cold air over the cylinder).

5

4

3

2

1

Temperature 0°C (32°F) or

colder:

Make a hole or remove the

plug so that the preheated air

from the cylinder can pass

into the carburetor area

preventing for instance icing

on the air filter.

For temperatures below -5°C

(23°F) and/or in snow

conditions there is also:

• a special cover (A) for the

Clean the cooling system with a brush once a week, more often in demanding conditions. A dirty or blocked cooling system results in the saw overheating which causes damage to piston and cylinder.

starter housing,
• a winter plug (B) for the air
intake that is fitted as
shown.	H
These reduce the air flow and	H
prevent large amounts of snow
from being sucked into the
carburetor chamber. NOTE!
When the winter plug is fitted
the winter flap must be open.

IMPORTANT! If the temperature rises above -5°C (23°F) or 0°C (32°F) respectively the saw MUST be restored to its normal settings. Otherwise there is a risk of overheating, which can cause severe engine damage.

IMPORTANT! Any maintenance other than that described in this manual must be carried out by your servicing dealer.

32 – English