Jonsered CS 2141 Contents, Epa Epa, Before using a new saw, Safety instructions, What is what?

CONTENTS

Before using a new saw

•Read the instructions carefully.

•Check cutting equipment is correctly fitted and adjusted. See page 25.

•Refuel and start the saw. Check the carburetor settings. See pages 26-29.

•Do not use the saw until sufficient chain oil has reached the chain, see page 14.

IMPORTANT! If the carburetor mixture is too lean it greatly increases the risk of engine failure.

Poor maintenance of the air filter will cause carbon build-up on the spark plug and lead to difficult starting.

If the chain is badly adjusted it will cause increased wear or damage to the bar, drive sprocket and chain.

Maintenance, replacement, or repair of the emission control devices and systems may be performed by any nonroad engine repair establishment or individual.

WARNING!

Under no circumstances may the design of the machine be modified without the permis- sion of the manufacturer. Always use genuine spare parts/accessories. Non-authorized modifications and/or accessories can result in serious personal injury or the death of the operator or others.

Your warranty may not cover damage or liability caused by the use of non-authorized accessories or replacement parts.

A chain saw is a dangerous tool if used care- lessly or incorrectly and can cause serious, even fatal injuries. It is very important that you read and understand these instructions.

Warning! The inside of muffler contain chemicals that may be carcenogenic. Avoid contact with these elements in the event of damaged muffler.

You will find the following labels on your chain saw:

EPA I:

EPA II:

The Emissions Compliance Period reffered to on the Emissions Compliance label indicates the number of operating hours for which the engine has been shown to meet Federal emission requirements.

Category C = 50 hours, B = 125 hours, A = 300 hours.

Contents
Key to symbols	2
Safety instructions
Personal protective equipment	4
Chain saw safety equipment	4
Inspecting, maintaining and servicing chain saw safety
equipment	8
Cutting equipment	10
How to avoid kickback	16
General safety precautions	18
General working instructions	19
What is what?
What is what?	24
Assembly
Mounting guide bar and chain	25
Fuel handling
Fuelmix	26
Fuelling	27
Start and stop
Start and stop	28
Maintenance
Carburetor	29
Starter device	30
Air filter	31
Spark plug	31
Muffler	31
Needle bearing maintenance	31
Adjustment of the oil pump	31
Cooling system	32
Centrifugal cleaning	32
Winter use	32
Daily maintenance	33
Weekly maintenance	33
Monthly maintenance	33
Technical data
CS 2141	34
CS 2145	34
CS 2150	34
Emission Control Warranty Statement
Your warranty rights and obligations	35

Jonsered has a policy of continuous product development and therefore reserves the right to modify the design and appearance of products without prior notice.

English – 3