Marantz MV8300_U1B Connections, Basic Connection, Check contents, Connect VCR to power source

Make sure the package contains all of the accessories listed in “SPECIFICATIONS” (
pg. 87).

Situate VCR

Place the VCR on a stable, horizontal surface.

INSTALLING YOUR NEW VCREN 7

Connections	Basic Connection
	1
		Check contents

Antenna or Cable

			ANTENNA IN
			(Antenna or cable input)
	Coaxial Cable
	Flat Feeder
		Matching
AC Outlet	Transformer
	(not supplied)
AC Power
Cord
			COMPONENT		VHF/UHF
					ANTENNA
			VIDEO OUT
		Y PB/CB	PR/CR		IN
		OUT		IN		i.LINK IN/OUT
						DV IN
		S VIDEO	IN(L-1)	S VIDEO		S400
	CABLE BOX				ANTENNA	DIGITAL OUT
	REMOTE PAUSE/	R AUDIO L VIDEO	R AUDIO L	VIDEO	OUT	OPTICAL
						PCM/DOLBY DIGITAL
	AV COMPULINK
						D THEATER
			IN(L-2)			REGION 1

Back of VCR

AUDIO OUT	VIDEO OUT	ANTENNA
		OUT

2

3 Connect VCR to TV

The following connections are required.

1Disconnect the TV antenna from the TV.

2 Connect the TV antenna cable to the ANTENNA IN terminal on the rear of the VCR.

3 Connect the supplied RF cable between the ANTENNA OUT terminal on the rear of the VCR and the TV’s antenna input terminal.

4 Connect an audio/video cable between the AUDIO/VIDEO OUT connectors on the rear of the VCR and the audio/video input connectors on the TV.

S-VIDEO Connection

●If you have a TV with S-VIDEO input terminals, see “S-VIDEO Connection” on page 8.

Component Video Connection

Audio Cable		● If you have a TV with component video input
		terminals, see “Component Video Connection” on
(supplied)	Video Cable
		page 8.
To Audio	(not
Input	supplied)	Connect VCR to power source
Connectors
To Video		4 Connect the AC power plug to the AC outlet.
Input
Connectors		● The clock and tuner channels will automatically
	RF Cable	be set when the antenna is connected and when
		the AC power cord is first connected to an AC
	(supplied)
		power outlet ( pg. 9).
To 75 Ω terminal		(If “Auto” or channel numbers are displayed on the
		front display panel before the VCR is turned on, the
		clock and tuner channels are being set automatically.
TV		Wait until the clock time is displayed on the front
		display panel before turning on the VCR.)
		Final preparation for use
		5 Turn on the VCR.
		● You can now perform basic playback
		( pg. 21) or basic recording ( pg. 26).
		NOTES:
		● Your TV must have audio/video input connector for the
		connection to the VCR.
		● Even if you are using audio/video cables to connect your VCR
		to your TV, you must also connect it using the RF cable. This
		will ensure that you can record one show while watching
		another ( pg. 29).
		● For full identification of the VCR’s rear panel, refer to the
		Index ( pg. 83).
		● If you cannot see the pictures on the TV screen when you
		play back a tape, set “TV OUTPUT 1” to the appropriate
		mode ( pg. 56).

HM-DH40000U-EN01-09 7 1/28/3, 9:51 AM