Marantz MV8300_U1B manual  S-Vhs Et

	EN 59
	* The default setting is bold in the table below.
 S-VHS ET	This function allows you to record on VHS tapes with S-VHS picture quality. Tapes
ON	recorded using this function can be played back on a VCR equipped with the S-VHS ET
OFF	function. The S-VHS indicator lights up on the front display panel when “S-VHS ET” is set
	to “ON”.
	NOTES:
	● Before recording, make sure that “V. CALIBRATION” is set to “ON” ( pg. 54).
	● You cannot activate the S-VHS ET function...
	– while recording is in progress.
	– while timer-recording or Instant Timer Recording ( pg. 28) is in progress.
	– while Video Calibration ( pg. 54) is in progress.
	● S-VHS ET does not work with S-VHS tapes.
	● To keep the highest quality recording and playback pictures over a long period of time, S-VHS recording
	on S-VHS tapes is recommended.
	● Use of high grade tapes are recommended for S-VHS ET recordings.
	On some tapes, picture quality will not improves even if the S-VHS ET function is used. Check the
	recording quality before you start important recordings.
	● You can play back S-VHS ET recordings on most of S-VHS VCRs and of VHS VCR equipped with SQPB
	(S-VHS QUASI PLAYBACK) function. (Notice some VCRs are not compatible with this function.)
	● While playing back a tape recorded with this function on some tapes, noise may appear. (If playback
	picture becomes blurred or interrupted, use a cleaning cassette.)
	● During special effect playback ( pg. 31), noise may appear. If special effect playback is performed
	frequently on a tape recorded with this function, the tape may be damaged and picture may be
	deteriorated.
 DISPLAY	When this function is set to “OFF”, only “:” appears on the front display panel.
ON	NOTE:
OFF
	Even if you set “DISPLAY” to “OFF”, each item appears on the front display panel in the following
	cases;
	● when the timer-recording is in progress/in the timer standby mode ( pg. 34 – 41)
	● in the satellite Auto Recording standby mode ( pg. 62)
	● during Plug & Play setting ( pg. 9)
	● when you press REC ( ¶ ) twice for the ITR ( pg. 28)
	● when you set the remote control code ( pg. 71)
	● when you press DISPLAY, the current status appears for a few seconds.

HM-DH40000U-EN53-63 59 1/22/3, 5:45 PM