HOW to Raise the Hood

Before the trouble-shooting steps on this page can be performed, the Hood (42) must be raised. Refer to the inset drawing below. Remove the three 3/8Ó Button Head Screws (65) and the three 3/8Ó Lock Washers (66) from the Upright (6).

65	66
6
	66 65

remove, the indicated #8 x 3/4Ó Screw (53). Slide the Reed Switch slightly closer to or farther away from the Magnet. Make sure that the Magnet will not hit the Reed Switch. Retighten the Screw. Turn the Flywheel for a moment. Repeat until the console displays cor- rect feedback. When the Reed Switch is correctly adjusted, reattach the hood.

HOW TO ADJUST THE V-BELT

If the V-belt (44) slips as you exercise, it should be adjusted. To adjust the V-belt, first raise the hood (see HOW TO RAISE THE HOOD at the left).

65	66
	42
53
	53
76

While another person holds the hood, locate the V-belt (44). To tighten the V-belt, turn the 5/16Ó Hex Nut (47) slightly; be careful not to overtighten the V-belt. When the V-belt is properly adjusted, reattach the hood.

Next, remove the #8 x 3/4Ó Screws (53) and the Star Washer (76) attaching the Hood (42). Raise the Hood as far as possible.

HOW TO ADJUST THE REED SWITCH

If the console does not display correct feedback, the Reed Switch (52) should be adjusted. To adjust the Reed Switch, first raise the hood (see HOW TO RAISE THE HOOD above).

HOW TO ADJUST THE RANGE OF RESISTANCE

If the resistance of the pedals is too high when the resistance knob is adjusted to the lowest setting, the Resistance Control Cable (48) should be adjusted. To adjust the Cable, first raise the hood (see HOW TO RAISE THE HOOD at the left).

While another
person holds the
hood, locate the
end of the
Resistance Control	48
Cable (48) below	48
Cable (48) below
the flywheel. To
decrease the resis-	Nut A	Nut B

While another person holds the hood, locate the Reed Switch (52) on the right side of the frame. Turn the Flywheel (30) until the Magnet

(79)is aligned with the Reed Switch. Loosen, but do not

30
79
53	52

tance of the ped-
tance of the ped-		Bracket
als, loosen nut A		Bracket
als, loosen nut A
one or two turns
one or two turns
and then tighten

nut B against the bracket. Repeat until the range of resistance is adjusted as desired. Then, reattach the hood.