Reebok Fitness RBEL68082 manual Assembly

Page 6

ASSEMBLY

Assembly requires two persons. Place all parts of the elliptical crosstrainer in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.

Assembly requires the included allen wrench

and push nut tool

, and your own phillips

screwdriver

rubber mallet

and two adjustable wrenches

.

1.Attach a Wheel Bracket (82) to the front of the Frame

(1) with a 3/8Ó Button Head Screw (65) and a 3/8Ó Flange Nut (88). Attach a Wheel (83) to the Wheel Bracket with a 3/8Ó x 1 3/4Ó Bolt (84) and a 3/8Ó Nylon Locknut (85). Make sure that the Wheel turns after you have tightened these parts. Attach the other Wheel Bracket and Wheel to the Frame in the same way.

Press two 2Ó x 3Ó Caps (38) onto the front of the Frame (1). Press the other two 2Ó x 3Ó Caps onto the back of the Frame (not shown).

2.Hold the Upright (6) in the position shown. Carefully pull the Resistance Control Wire (48) and the Reed Switch Wire (52) up through the Upright until there is no slack between the Upright and the Frame (1).

Slide the Upright (6) onto the Frame (1). Be careful to avoid pinching the Resistance Control Wire

(48)and the Reed Switch Wire (52). Tighten a 3/8Ó Button Head Screw (65) and a 3/8Ó Lock Washer

(66)into the front of the Upright and the Frame. Next, tighten two 3/8Ó Button Head Screws and 3/8Ó Lock Washers into the sides of the Upright and the Frame. Note: It may be necessary to loosen the front Button Head Screw slightly in order to attach the other two Button Head Screws. Firmly tighten all three Button Head Screws.

3.The Console (43) requires two ÒAAÓ batteries (not included). Alkaline batteries are recommended.

To install batteries, turn over the Console (43) (see the inset drawing). Insert two batteries into the bat- tery clip. Make sure that the negative ends of the batteries (marked ÒÐÓ) are touching the springs in the battery clip.

1

 

 

 

 

83

65

85

 

 

 

 

 

 

84

 

 

 

 

 

82

 

 

 

38

88

1

 

 

 

 

2

 

 

 

 

 

 

 

 

48

 

 

 

 

52

 

6

 

 

 

 

65

 

 

 

 

66

 

 

65

 

 

 

 

66

 

65

 

 

 

1

 

 

 

 

3

 

 

 

 

 

43

 

 

 

 

 

 

43

Battery Clip

 

 

 

 

Batteries

6

Image 6
Contents QUESTIONS? Model No. RBEL68082 Serial NoCustomer HOT Line Table of Contents Limited WarrantyImportant Precautions Back Before YOU BeginFront Right SidePart Identification Chart Assembly Page HOW the Pacer Programs Operate HOW to USE the Elliptical CrosstrainerDescription of the Console Description of the Monitor ModesSelect one of the three pacer programs or the manual mode STEP-BY-STEP Console OperationBegin your workout HOW to Exercise on the Elliptical Crosstrainer Maintenance and TROUBLE-SHOOTINGHOW to Adjust the Resistance of the Pedals Battery ReplacementHOW to Adjust the Reed Switch HOW to Raise the HoodHOW to Adjust the V-BELT HOW to Adjust the Range of ResistanceConditioning Guidelines WHY EXERCISE?HOW to Measure Your Heart Rate Exercise IntensityExercise Frequency Suggested StretchesPart LISTÑModel No. RBEL68082 Key No. Qty DescriptionNo. RBEL68082 HOW to Order Replacement Parts