SM61 Unpacking & Assembly Instructions
Figure 17. Adjustable crossover cable end detail.
Using a 7/8” wrench, tighten the jam nut onto the adjustable pulley threads as shown in Figure 17. Place a rubber cap on the top of the cable as shown in Figure 17 (right).
Bolt the cable to the weight stacks as shown in Figure 18. Thread the 7/8” nut up on the cable bolt as shown at left. Screw the bolt down into the weight stack as shown at right. Tighten the bolt with a 7/8” combination wrench.
Figure 18. Screw the cable into the weight stack.
14