Hardware . Cable jam nut, Hardware . Cables

The parts shown in Hardware Figure 1 are used to assemble the SM60. They are:

A.7/16” x 6” hex head bolt (used to bolt the tricep top beams, lat top beams, and connecting beam to the tops of the cubes)

B.7/16” flat washer

C.7/16” cap washer (used on the head end of the 6” bolt so end cap will fit on the nut)

D.7/16” hex head nut

E.3/8” x 3” hex head bolt (used to bolt the tricep pushdown beams to the connecting beam)

F.3/8” x 2-3/4” hex head bolt (used for all other connections)

G.End caps (bolt covers)

H.3/8” flat washer

J.3/8” end cap washers (end caps snap onto them)

K.3/8” Nyloc (locknut)

The part shown in Hardware Figure 2 is the 9/16” cable jam nut that’s used to secure the cables to the weight stacks.

Hardware Figure 2. Cable jam nut.

M. Cable jam nut

Hardware Figure 3 shows the types of cables that are included with the SM60.

N PQ

N. Lat pulldown cables (same as tricep cable) (2)

P. Tricep cable (same as lat pulldown cables) (2)

Q. Crossover cables (ball end) (2)