6.Assemble the OUTPUT CAM (15), OUTPUT PLATE (16), and OUTPUT RING (17) using three M10 X 45mm BOLTS (18) and three 3/8" SAE WASHERS (5) as shown. Tighten the BOLTS securely.
7.Assemble the REAR SHROUD (19) and FRONT SHROUD (20) to the TOWER (3) using four M10 X 20mm BOLTS (21), four 3/8" SAE WASH- ERS (5) as shown. Be sure all tabs along the sides and top of the SHROUDS are fully engaged in the slots located inside the TOWER. Tighten the BOLTS securely. Do not
8.Secure the OUTPUT CAM ASSEMBLY (A) to the TOWER AXLE (B) using one M10 X 25mm BOLTS (22), one 3/8" SAE WASHERS (5) and one PLATE (23) as shown. Tighten the BOLT securely.
IMPORTANT: Be sure the OUTPUT CAM ASSEMBLY is oriented as shown before secur- ing it to the TOWER HUB.
9.Attach the CAM GUARD (24) to the FRONT SHROUD (20) using two M5 X 10mm PHILLIPS SCREWS (25). Tighten the SCREWS securely. Do not overtighten the SCREWS.