Seated Leg Curl
Assembly Instructions
1.LOOSELY assemble the FRONT BRACE (1) and REAR BRACE (2) to the TOWER (3) using four M10 X 130mm BOLTS (4), eight 3/8" SAE WASH- ERS (5) and four M10 NYLOCK NUTS (6) as shown.
2.LOOSELY assemble the SEAT FRAME (7) to the FRONT BRACE (1) and REAR BRACE (2) using four M10 X 90mm BOLTS (8), eight 3/8" SAE WASHERS (5) and four M10 NYLOCK NUTS (6) as shown.
3.LOOSELY assemble the TOP BRACE (9) to the SEAT FRAME (7) and TOWER (3) using two M10 X 35mm BOLTS (10), four 3/8" SAE WASH- ERS (5) and two M10 NYLOCK NUTS (6) at the SEAT FRAME and two M10 X 70mm BOLTS (11), four 3/8" SAE WASHERS (5) and two M10 NYLOCK NUTS (6) at the TOWER as shown.
4.Tighten all BOLTS and NUTS securely.
5Assemble the MAIN PIVOT BRACKET (12) to the TOWER (3) using one TOWER SUPPORT PLATE (13) (as shown), two M10 X 75mm BOLTS (14), four 3/8" SAE WASHERS (5) and two M10 NYLOCK NUTS (6) at the top of the MAIN PIVOT BRACKET. Use one M10 X 70mm BOLT (11), two 3/8" SAE WASHERS (5) and one M10 NYLOCK NUTS (6) at the bottom of the MAIN PIVOT BRACKET. Tighten the BOLTS and NUTS securely.