13.Insert the MEDIUM SPACER (33), two BEARINGS (34) and one SHORT SPACER (35) into the KNEE SUPPORT (26) as shown. Carefully insert the KNEE HANDLES (36) into the KNEE SUPPORT and secure it with one M10 X 25mm HEX BOLT (37) and one FENDER WASHER (48). Tighten the BOLT securely.
Insert the BEARING HOUSING CAP (38) as shown.
14.Attach the KNEE PAD (39) to the KNEE HANDLES (36) using two M10 X 25mm BOLTS (22) and two 3/8" SAE WASHERS (5). Tighten the BOLTS securely.
15.Attach the PAD SUPPORT PLATE (50), SEAT PAD LEAD EDGE (40) and SEAT PAD (41) to the SEAT FRAME (7) using six M10 X 25mm BOLTS
(22)and six 3/8" SAE WASHERS (5). Tighten the BOLTS securely.
16.Slide the SHAFT COLLAR (42) over the long shaft of the WORKARM (29). Slide the ROLLER PAD (43) over the long shaft of the WORKARM in simi- lar fashion. Install one M10 X 35mm BOLT (10), one 3/8" SAE WASHERS
(5)and one PLATE (23) to the end of the long shaft of the WORKARM as shown. Tighten the BOLT securely.
Slide the SHAFT COLLAR against the ROLLER PAD and tighten the set screw securely.
Insert the BEARING HOUSING CAP (38) onto the end of the ROLLER PAD as shown.