Smith Machine PL06 Unpacking & Assembly Instructions
9.Tighten the bolts on the carriage. Using a 5/32” hex head driver and 3/8” combination wrench, securely tighten the eight hex head bolts on each bar carriage. Bar adjustments may be made by loosening the carriage bolts and tightening them one at a time in the order shown in Assembly Figure 9 below. Start in the top right corner and move to the bottom left corner. Continue the pattern of top left to bottom right as shown in Assembly Figure 9.
3 | 1 |
8 | 5 |
7 | 6 |
2 | 4 |
Assembly Figure 9. Carriage bolt tightening pattern.
BAR SPACERS
The PL06 includes plastic bar spacers that should be inserted between the bar and the bar carriages if there is extra play in the bar. The spacers are cut so that they can be easily slipped over the bar. Insert one on each side of the bar as shown in Assembly Figure 10.
Assembly Figure 10. Bar spacers.
11