Smith Machine PL06 Unpacking & Assembly Instructions
Assembly Figure 5. Remove the right bar carriage.
5.Remove the right bar carriage. Have one person take the bar carriage and pull it down from the top of the PL06. This person will also need to hold down the cable that the carriage is bolted onto. Have a second person remove the carriage by loosening the eight bolts (shown in Assembly Figure 5) using a 3/8” combination wrench and a 5/32” hex key wrench. You may also remove the bar carriage entirely by removing the cable jam nuts shown in Assembly Figure 8.
6.Insert the bar into the right side carriage. Swing the carriage out by pulling down on the cable and slide the bar into the right side carriage. Make sure the bar hooks are positioned upward as shown in Assembly Figure 6. Insert the bar carriage into the bar hook as shown in Assembly Figure 6 to hold the bar in place. Retighten the eight bolts inserting a washer under the bolt.
Assembly Figure 6. Insert the bar into the right carriage and place on bar hook.
9