Assembly

Smith Machine PL06 Unpacking & Assembly Instructions

1.Attach the front (small) brace. With Person 2 holding the left side and Person 3 holding the right side, secure the front brace (shown in Assembly Figure 1) by sliding the two bottom bolts through the bottom holes in the front brace (circled in Assembly Figure 1). Make sure the Life Fitness nameplate is positioned toward the outside of the machine as shown in Assembly Figure 1. The two bolts have already been inserted through the sides of the PL06. Tighten these two bolts to stabilize the PL06. Loosely tighten the nuts on the bolts to make attaching the back brace easier.

Insert two 4-1/4” bolts into the top two holes from the outside of the machine and loosely tighten them. The flat washers and end cap washers need to go onto the bolts in the top holes using the configuration shown in Assembly Figure 2.

Assembly Figure 1. Attach the front brace.

NOTE: The two lower bolts on the front brace will NOT have washers or end caps on the head of the bolt.

Assembly Figure 2. Bolt, flat washer, nut, end cap washer and end cap configuration

(typical for both 4” and 4-1/4” bolts).