IMPORTANT!
UNCOIL AND STRAIGHTEN ALL CABLES TO REMOVE ALL TWISTS BEFORE
INSTALLING.
STEP 10:
A. Assemble the Weight Stack Pin (27) to the
Head Plate Assembly (23) as shown in
Figure 10.
B. Screw the long threaded end of the Weight
Stack Cable (29) into the end of the Head
Plate Assembly (23). See Figure 10.
C.Route the Weight Stack Cable (29) around the pulleys in the Boom Plates (14 & 15) as shown in Figure 10.
Note: Make sure the cable runs in the grooves of the pulleys.
D.Tighten the two 3/8 x
Note: Make sure the guards are oriented correctly.
E.Assemble two Pulley Plates (10) around one
FIGURE 10
18