15.Press a 50mm Square Outer Cap (17) onto each end of the Small Stabilizer (25).
Attach the Small Stabilizer (25) to the Front Leg (19) with two M10 x 65mm Carriage Bolts (40) and two M10 Nylon Locknuts (11). Note: There is an inden- tation around the holes on one side of the Small Stabilizer. This side must be facing the floor.
16.Press a 50mm x 70mm Outer Cap (10) onto each end of the Large Stabilizer (26).
Turn the Large Stabilizer (26) so the warning decal is in the position shown. Attach the Large Stabilizer to the Bench Frame (5) with two M10 x 65mm Carriage Bolts (40) and two M10 Nylon Locknuts (11).
17.Attach the Front Leg (19) to the Bench Frame (5) with two M10 x 70mm Bolts (46), a Small Support Plate (16), and two M10 Nylon Locknuts (11).
18.Press two 20mm x 40mm Inner Caps (28) into each Backrest Tube (27). Press four 20mm x 40mm Inner Caps into the Backrest Adjustment Bracket (36).
Lubricate an M10 x 180mm Bolt (22). Attach the Backrest Tubes (27) to the welded tube on the Backrest Adjustment Bracket (36) with the Bolt, two M10 Washers (6), and an M10 Nylon Locknut (11).
Make sure that the Backrest Tubes are turned as shown. The indicated holes are not centered in the Backrest Tubes but are closer to one side. Turn the Backrest Tubes so the holes are closer to the floor. Do not over tighten the Nylon Locknut; the Backrest Tubes must pivot easily.
15 |
|
|
|
|
|
|
| 19 |
|
| 17 | 11 |
|
|
|
|
| 25 |
|
|
| 40 |
| 17 |
|
|
|
| |
16 |
|
|
|
|
|
| 5 |
| 11 |
|
|
|
| |
|
| 10 |
| |
|
|
| 26 | 10 |
|
|
| 40 |
|
17 |
|
|
|
|
|
|
| 11 |
|
| 16 |
|
| |
|
|
|
| 5 |
46 |
|
| 11 |
|
|
|
|
| |
|
|
| 19 |
|
18 | Lubricate | 27 | 28 | |
22 |
| 6 |
|
|
Holes |
|
| 6 |
|
|
|
|
| |
|
|
|
| 11 |
28 |
|
|
|
|
| 28 | Welded |
| 28 |
|
|
| ||
|
| 36 |
| |
|
| Tube |
| |
|
|
|
| |
11