23.Place the Seat Support Tube (37) on the Bench Frame (5) so that the Seat Adjustment Bracket (45) fits over the welded pin (not visible in the drawing) on the side of the Bench Frame.
Lubricate an M10 x 80mm Bolt (56). Attach the Seat Support Tube (37) to the indicated bracket on the Bench Frame (5) with the Bolt and an M10 Nylon Locknut (11). Note: Do not over tighten the Nylon
Locknut; the Seat Support Tube must pivot easily.
24.Turn the Seat (14) as shown. Attach the wide end of the Seat to the bracket on the Seat Support Tube (37) with two M6 x 16mm Screws (3).
Tilt the Seat Support Tube (37) upwards and attach the narrow end of the Seat (14) to the Seat Support Tube with an M6 x 38mm Bolt (60) and an M6 Washer (30).
25.Attach the Curl Pad (13) to the bracket on the Front Leg (19) with two M6 x 16mm Screws (3).
23 | 37 |
| |
| Lubricate |
| 45 |
| 56 |
Welded |
|
Pin |
|
| 5 |
| 11 |
24 |
|
14 |
|
| 37 |
| 30 |
| 3 |
| 60 |
25 | 13 |
| |
| 3 |
| 19 |
26.Make sure all parts are properly tightened before you use the weight bench. The use of all remaining parts will be explained in ADJUSTING THE WEIGHT BENCH starting on the following page.
13