English
To assemble and connect the AM loop antenna
To assemble the AM loop antenna
To connect the AM loop antenna
1 Hold | 2 Insert | 3 Release |
•If the AM loop antenna wire or speaker cords are covered with vinyl, remove the vinyl to expose the tip of the antenna by twisting the vinyl.
•Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord. Also keep the antennas away from metallic parts of the System, connecting cords, and the AC power cord. This could cause poor reception.
To connect the speaker cords
Connect the right speaker to the R terminals, and the left speaker to the L terminals.
1 Hold | 2 Insert | 3 Release |
When connecting the speaker cords, match the polarity of the speaker terminals: gray cord (+) to red (+), and gray cord with black stripe
• DO NOT connect more than one speaker to each terminal.
•DO NOT allow the conductor of the speaker cords to be in touch with the metallic parts of the System.
Changing the Scanning Mode | Remote |
ONLY |
This System supports progressive scanning.
If you connect a progressive TV through the COMPONENT jacks, you can enjoy a high quality picture from the
| PROGRE |
| INTER |
(at the same time) |
|
PROGRE | Progressive scanning. |
(Progressive) | For a progressive TV. The |
| PROGRESSIVE indicator lights. |
INTER | Interlaced scanning. |
(Interlaced) | For a conventional TV. |
6