Assembly

* Short screw will come installed in unit, it must be removed before this assembly step begins. See Figure 2*

Step 2

A)Insert Left Handlebar into the opening at the top of the left side on the Main Frame. Secure to the Pivot Arm using a Small Washer and a M8*45mm Hex Bolt.

B)Slide two of the Cover Plates over the holes for the Short Screws.

C)Attach the Small Cover and secure in place using two Short Screws.

B)Slide a Grommet down the Left Handlebar and snap it onto the Main Frame. Note: Make sure the Grommet is facing down as shown.

D)Repeat A, B, and C to complete the right side.

Figure 2

Main Frame

Left Handlebar

M8*45mm Hex Bolt

Grommet

Small Cover

Small Washer

* Short Screw *