Daybreak Fitness WLRX10170 manual Assembly

Page 5

ASSEMBLY

Place all parts of the DAYBREAK in a cleared area and remove the packing materials; do not dispose of the packing materials until the DAYBREAK is fully assembled. For your convenience, the DAYBREAK can be

assembled in three simple steps. An adjustable wrench (not included) is required.

1.Unfold the massage chair to the position shown at the right. Make sure that the Massage Pad (12) is correctly positioned on the Seat Frame (10) and the Back Frame (15).

Attach one of the Arms (9) to the Seat Frame (10) with two 5/16Ó x 2Ó Carriage Bolts (1), two 5/16Ó Washers (4), and two 5/16Ó Nylon Locknuts (5) as shown.

Attach the other Arm (9) to the Seat Frame (10) in the same manner.

2.Connect the wire harness on the Hand Control (14) to the wire harness on the Massage Pad (12). Refer to the inset drawing. Make sure that the indicated latch on the wire harness is engaged. If the wire harnesses do not fit together easily, turn them. Do not force the wire harnesses together.

3.Plug the Power Cord (16) into the jack on the Massage Pad (12).

1

 

9

 

9

 

 

1

 

1

10

 

 

4

4

12

 

 

5

15

2

 

 

 

 

12

14

 

Latch

 

 

3

12

16

4. Make sure that all parts of the massage chair are properly tightened.

5

Image 5
Contents Customer HOT Line QUESTIONS?Table of Contents Important Precautions Read and Follow ALL Instructions Before YOU Begin Assembly Diagram of the Hand Control Features of the Massage Chair HOW to Operate the Massage ChairHOW to USE the Hand Control HOW to Turn on the PowerHand Control TROUBLE-SHOOTING HOW to Activate the BUILT-IN HeaterHOW to Turn OFF the Power HOW to Attach the Massage PAD to the Frame Maintenance and Storage Part LISTÑModel No. WLRX10170 Exploded DRAWINGÑModel No. WLRX10170 Limited Warranty HOW to Order Replacement Parts