14.Cut the plastic zip tie (not shown) from the Cable (35). Be careful not to damage the Cable.
Pull on the Cable (35) until you have enough slack to route the Cable around the Pulley (41) attached to the Right Butterfly Arm (15). Tighten the 3/8Ó x 2Ó Bolt (43). The Cable Trap (not shown) must be oriented as shown in step 12.
Route the Cable (35) around the Pulley (41) on the Left Butterfly Arm (14) in the same manner.
15.Pull the remaining slack in the Cable (35) as shown. Wrap the Cable around a Pulley (41). Attach the Pulley and a Cable Trap (67) to the Lift Tube (11) with a 3/8Ó x 2Ó Bolt (43) and a 3/8Ó Nylon Locknut (39).
16.Attach the Name Plate (7) to the Frame (2) with two 3/4Ó Tap Screws (62).
17.Insert a 1/4Ó x 3 1/2Ó Carriage Bolt (59) through the center hole in a Seat Plate (29). Attach the Seat Plate to the Backrest (22) with two 1/4Ó x 3/4Ó Bolts (56).
Insert the 1/4Ó x 3 1/2Ó Carriage Bolt (59) through the indicated hole in the Frame (2). Tighten a 1/4Ó Nylon Locknut (54) with a 1/4Ó Washer (55) onto the Carriage Bolt.
Attach the other end of the Backrest (22) to the Frame (2) with a 1/4Ó Washer (55) and a 1/4Ó x 3.1/2Ó Bolt (58).
10
14 |
| 35 |
|
| |
15 |
|
|
43 |
| 41 |
|
| 14 |
15 |
|
|
|
| 35 |
39 |
| 41 |
|
| |
67 | 43 | |
|
| 11 |
16 |
|
|
7 |
|
|
|
| 2 |
62 |
|
|
17 |
| 55 |
|
| |
|
| 58 |
22 |
|
|
29 |
| 55 54 |
56 | ||
59 |
|
|