Assembly
Step 13: Cable and Pulley Routing the Rear Pulleys
Parts
•Completed Assembly (from step 12)
Tools
•Adjustable Wrench (not included)
13-1Remove the 3/8” x 4 1/2” Hex Head Bolt and the 3/8” Washer in the center of the Lat Pulley Housing.
13-2Remove the two pulley wheels from the Lat Pulley Housing.
13-3Unwrap the Right Pulley Cable from the Right Frame Rail and thread it under and then over one of the pulley wheels. Pinch the Right Pulley Cable to the pulley wheel until installed.
13-4Unwrap the Left Pulley Cable on the Left Frame Rail and thread it under and then over the other pulley wheel.
13-5Put the pulleys with the cables wrapped around them back into the Lat Pulley Housing.
13-6Replace and tighten the 3/8” x 4 1/2” Hex Head Bolt and the 3/8” Washer in the center of the Lat Pulley Housing.
18
