Assembly Guide
Step 4 - Attach the Chest Bar with Pulleys to the Main Assembly
Locate the following items:
•From Step 3 - Main Assembly
•Item #6 - Chest Bar
•Item #31 - Chest Pulleys
•Item #K - (2) 3/8" X 5" Button Head Screws
•Item #N - (4) 3/8" Washers
•Item #O - (2) 3/8" Nylock Nuts
Figure 4
K
N
Chest Bar Brackets
6
Line up the bolt holes in the brackets on the Chest Bar (Item #6) with the lowest bolt holes on the Lower Lat Tower, as shown in Figure 4.
Place (2) 3/8" Washers (Item #N) over the end of (2) 3/8” X 5" Button Head Screws (Item #K) - one washer per screw. Insert the screws through the lined up holes in the Chest Bar and the Lower Lat Tower, and secure each screw by placing (1) 3/8" Washers and (1) 3/8" Nylock Nuts (Item #O) over the end of each screw.
Remove the (2) 1/4” X 1/2” Socket Head Cap Screws from the underside of each end of the Chest Bar. Slide the Chest Pulleys (Item #31) over each end of the Chest Bar. Install
(1)1/4” X 1/2” Socket Head Cap Screw into the hole on the underside of each end of the Chest Bar. This prevents the Chest Pulleys from sliding off
Completely tighten hardware installed during Step 4.
Step 5 - Attach the Seat Bracket to the Seat Pad
Locate the following items:
•Item #7 - Seat Pad
•Item #8 - Seat Bracket
•Item #C - (4) 5/16" X 3/4" Button Head Screws
•Item #M - (4) 5/16" Washers
Place the Seat Pad (Item #7) on the floor,
Place (4) 5/16"Washers (Item #M) over (4) 5/16" X 3/4" Button Head Screws (Item #C) - one over each screw, and use those screws to secure the Seat Bracket to the Seat Pad.
Completely tighten hardware installed during Step 5.
Figure 5 |
M |
7 |
O
Base Platform/
Lower Lat Tower
Assembly
C
8
Angled
Edge