Leg Exercises
Seated Hip Abduction
Muscles worked:
Piriformis; Gluteus Maximus
Bench Position:
Flat Bench Forward
Accessory:
Ankle Cuff
Pulleys:
Chest Bar
Success Tips
•Keep your spine straight and your hips
•Use only a small range of motion.
•Keep your hips motionless throughout this exercise.
START
START
•Sit sideways on the bench and attach an Ankle Cuff to the ankle farthest from the Power Rods®.
•Sit far enough from the Power Rods® that there is tension in the cable at the start of the exercise.
•Lift leg with cuff in front of you, at a 45° angle from your trunk (toward Power
•You may hold onto the bench for added stability.
FINISH
ACTION
•Slowly allow the attached leg to move outward, away from the Power Rods®, keeping your hips and spine perfectly still.
•Keeping the leg still, slowly move it back into the Start position.
Standing Leg Kickback — Hip and Knee Extension
Muscles worked:
Gluteus Maximus
Bench Position:
Removed
Accessory:
Ankle Cuff
Pulleys:
Chest Bar
Success Tips
•Keep your chest lifted, spine aligned, abs tight and a very slight arch in your lower back.
•Do not bend from waist or lower back.
START
START
•Stand to one side of the Seat Rail, facing the Power Rods®.
•Secure the Ankle Cuff around the ankle furthest from the rail. Bend this leg approximately 90°.
•Bend forward
FINISH
ACTION
•Extend the active leg backwards, straightening the knee.
•Slowly move your leg as far as you can, without allowing any movement at the waist, knee or lower back.
•Slowly return to the Start position.
62