LEG PRESS CABLE
LEG PRESS CABLE(234)
If previously installed, completely remove TOP CABLE(84), along with pulleys T1, T2, T3, T4 and T5. Remove the two bolts and attach the TOP BEAM into the FRONT UPRIGHT. Assemble TOP CABLE(84A) (from leg press box) and pulleys simultaneously. Insert threaded end of TOP CABLE(84A) into slot in front of TOP BEAM, over pulleys T1, T2, around pulley T3, and over T4. Run threaded end of TOP CABLE(84A) through SINGLE PULLEY BRACKET(211) and attach pulley G1 as shown. Finish by routing TOP CABLE(84A) over pulley T5 and attach threaded end of TOP CABLE(84A) into SELECTOR ROD. For safety reasons, the threaded end should be screwed in using at least half of the available screw length. The jam nut should be tightened to SELECTOR ROD to prevent loosening. Replace the two bolts that attach the TOP BEAM to the FRONT UPRIGHT and tighten. Make certain the TOP CABLE(84A) runs above these bolts. Attach RUBBER BUMPER(215) to top of SINGLE PULLEY BRACKET(21).
TOP CABLE(84A) |
| T2 | |
84A |
| T5T4 | T1 |
|
| ||
| T5 |
|
|
| 51 | 75 |
|
80 | 9 |
| 84A |
|
| ||
| 51 | 77 |
|
|
|
| |
| 65 | 90 | T3 |
| 75 | L5 | |
|
| ||
| T2 | T1 |
| T4 | |
T5 |
| |
|
| |
| T3 |
|
| L5 |
|
84A | G1 |
|
211 |
| |
|
| |
| 234 |
|
FLOATING PULLEY BLOCK(32)
TOP | P2 |
| |
CABLE(84A) | AB |
| |
T3 | CABLE(86) |
L5 | A2 |
| |
| L7 |
LOWER | LOWER |
CABLE(87) | CABLE(87) |
T3 | A2 |
|
L5 | L7 |
|
6