Getting Started

Type Help at the ‘Local_>’ prompt for assistance.

Enter Username> gopher

Local> SET PRIVILEGED

Password> system (not echoed)

Local>> DEFINE SERVER IPADDRESS 192.0.1.228

Local>> DEFINE SERVER SUBNET MASK 255.255.255.0

Any host wishing to access the ETS will have to be told the ETS’ IP address. This is typically configured in the UNIX file /etc/hosts or via a nameserver. Refer to the host’s documentation for additional information.

Using a BOOTP, DHCP, or RARP Reply

At boot time a host-based DHCP, BOOTP, or RARP server can respond to an ETS request for an available IP address. For information about configuring the DHCP, BOOTP, or RARP server, see your host documentation.

Using the Command Line Interface

1.Connect to the serial port (Port_1) using a console terminal or a terminal emulation program, and press Enter. The serial port settings are 9600 baud, 8 bits, 1 stop bit, no parity.

2.Become the privileged user.

Figure 3-6. Becoming the Privileged User

Local> SET PRIVILEGED

Password> system (not echoed)

Local>>

3. Enter the new IP address.

Figure 3-7. Configuring the IP Address

Local>> define server ipaddress 192.0.1.201

Local>> DEFINE SERVER SUBNET MASK 255.255.255.0

For additional command line reference (for use with Telnet or a terminal console), see the ETS Reference Manual available for download from www.lantronix.com/support/docs/index.html .

Was the Installation Successful?

If the ETS appears to be working and the unit is connected to the network, there are a couple of ways to confirm that the unit is visible to network hosts:

‹If the ETS has an IP address, ping it from a TCP/IP host.

‹If the ETS has an IP address, use EZWebCon to log into it.

When you are satisfied that the ETS is working properly, proceed to 3:Getting Started. If the ETS does not boot properly, see B:Troubleshooting.

18

ETS Installation Guide

Page 18
Image 18
Lantronix ETS32PR Was the Installation Successful?, Using a BOOTP, DHCP, or Rarp Reply, Using the Command Line Interface