Troubleshooting
Figure B-1. BCP Command Examples
Boot> SET IPADDRESS 192.0.1.229 Boot> SET SOFTWARE /tftpboot/ETS*.SYS Boot> SET LOADHOST 192.0.1.188 Boot> SET SECONDARY 192.0.1.22 Boot> FLASH
% Initialization begins in 5 seconds.....
These commands set the Server’s address, the software loadfile, and the loadhost’s IP address (as well as that of a backup loadhost). The server then reboots using the Flash command and will attempt to load the file ETS*.SYS from the host at 192.0.1.188.
Flush NVR | This command is used to restore the ETS’ |
| |
| settings. It will reset everything that is |
| configurable on the server, including the |
| unit’s IP address. |
Flash | This command will force the ETS to |
| download new operational code and reload |
| it into Flash ROM. This is necessary when a |
| new version of software is released and you |
| wish to upgrade your unit. If the server |
| cannot download the file, the code in Flash |
| ROM will still be usable. |
Help | Displays a |
| commands and what they do. |
Init 451 | Reboots the ETS after it has been |
| configured. If the ETS can find and load the |
| specified software loadfile, it will restart itself |
| with full functionality. If the loadfile is not |
| found, the server will attempt to reload |
| continuously. If there is an error, or if the |
| console’s Return key is pressed, the ETS |
| will |
| Program. |
SET BOOTP {Enabled, Disabled} | Enables or disables the sending of BOOTP |
| queries during the boot sequence. It is |
| enabled by default. |
SET DHCP {Enabled, Disabled} | Enables or disables the sending of DHCP |
| queries during the boot sequence. It is |
| enabled by default. |
SET Hardware | Specifies the last three numbers of the |
| server’s Ethernet address. The first three |
| numbers will be supplied automatically. |
| The Ethernet address should have been set |
| at the factory. Setting an incorrect address |
| could cause serious network problems. |
SET IPAddress ip_address | Specifies this server’s IP address. Uses the |
| standard numeric format. |
SET Loadhost ip_address | Specifies the host to attempt to load the file |
| from. The IP address should be in standard |
| numeric format (no text names are allowed). |
ETS Installation Guide | 51 |
