|
|
|
|
| Troubleshooting | |||
|
|
|
|
|
|
|
|
|
| Problem/Message | Error |
| Remedy |
| |||
|
|
| A | Reboot the unit. When the ETS is |
| |||
|
|
| may signal boot failure. | running normally, the OK LED |
| |||
|
|
|
|
| blinks every two seconds. |
| ||
|
|
|
|
|
|
|
| |
| The terminal shows a | The ETS is not connected | Ensure that the ETS is firmly |
| ||||
| Boot> prompt rather than | properly to the Ethernet. | connected to a functional and |
| ||||
| a Local> prompt. |
|
|
| ||||
|
|
| The ETS Ethernet address | The ETS Ethernet address is |
| |||
|
|
| is invalid. |
| located on the bottom of the unit. |
| ||
|
|
|
|
| Use the Set Hardware command to |
| ||
|
|
|
|
| set the correct address, then |
| ||
|
|
|
|
| reboot. See Entering Commands at |
| ||
|
|
|
|
| the Boot Prompt on page 50. |
| ||
|
|
| Init Noboot command was | See Entering Commands at the |
| |||
|
|
| entered. |
| Boot Prompt on page 50. |
| ||
| The ETS passes power- | If the OK LED blinks | Reboot the unit. If you get the same |
| ||||
| up diagnostics, but | rapidly, the Flash ROM | message, you will need to reload |
| ||||
| attempts to download | code may be corrupt. | Flash ROM. Refer to D:Updating |
| ||||
| new Flash ROM code |
|
| Software. |
| |||
| from a network host. |
|
|
|
|
|
| |
| If you did not request a |
|
|
|
| |||
|
|
|
|
|
|
| ||
|
|
| TFTP boot, the flash ROM |
|
|
|
| |
|
|
| code is corrupt. The unit |
|
|
|
| |
|
|
| will remain in boot mode. |
|
|
|
| |
|
|
|
|
|
|
|
|
|
DHCP Troubleshooting |
|
|
|
|
| |||
|
|
| Table | |||||
|
|
|
|
|
| |||
|
| Area to Check |
| Diagnosis/Remedy |
| |||
|
| DHCP is enabled on the | Use the Set Server DHCP Enabled |
| ||||
|
| ETS |
| command. If you manually enter an IP |
| |||
|
|
|
| address, DHCP is automatically disabled. |
| |||
|
| Make sure the DHCP | Check to see that the DHCP server is on |
| ||||
|
| server is operational. | and is functioning correctly. |
| ||||
|
| The ETS gets its IP | Refer to the DHCP Manager on your DHCP |
| ||||
|
| address from the DHCP | server for information about addresses in |
| ||||
|
| server |
| use. If the DHCP server doesn’t list your |
| |||
|
|
|
| ETS IP address, there may be a problem. |
| |||
BOOTP Troubleshooting
If the BOOTP request is failing and you have configured your host to respond to the request, check these areas:
Table
Area to Check | Explanation |
BOOTP is in your system’s /etc/services file
BOOTP must be an uncommented line in /etc/services.
ETS Installation Guide | 49 |
