Installation
Figure 2-6. Sample ETSPR Network Layout (ETS16PR shown)
To install the ETS, complete the following steps in order:
1.Attach the two rack mount brackets to your ETS and attach your bracketed ETS to your rack. The brackets should go on both front corners or both rear corners. (This is only necessary if you would like to mount the unit on a rack.)
Figure 2-7. Rack Mount Bracket Installation
2.Connect one or more serial devices to the ETS.
Note: The default serial port settings are 9600 baud, 8 bit characters, no parity, 1 stop bit, and
3.It is recommended to connect a terminal to the ETS console port (port 1). This will enable you to receive diagnostic and initial configuration messages.
4.Connect an Ethernet cable to either the
Note: The ETS will boot without a valid Ethernet connection, but it will pause to print a message (seen on the console port) asking if you want to stop at the Boot> prompt. If you do not respond to this message, it will wait for 10 seconds and then finish booting.
5.Attach one end of the power cable to the ETS and plug the other end into an electrical outlet.
6.Flip the power switch to turn the unit ON. The ETS will go through two steps to begin normal operation:
ETS Installation Guide | 13 |
