Assembly

To hire an authorized service technician to assemble the elliptical exerciser, call 1-800-445-2480.

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the

included hex keys, assembly requires a Phillips screwdriver , an adjustable

wrench , and a rubber mallet .

As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parenthe- ses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the parentheses is the quantity needed for assembly. Note: Some small parts may have been preassembled. If a part is not in the hardware kit, check to see if it has been preassembled.

Star Washer		M4 x 13mm		M6 Split	M8 Split	M10 Spacer		Wave Washer
(92)–3	Washer (93)–2		Washer (88)–8		Washer (72)–2	(76)–2		(98)–8
M10 x 20mm x		M10 x 25mm			M8 Nylon			M10 Nylon
1mm Washer			Washer		Locknut (96)–4			Locknut (97)–2
(81)–2			(94)–10
M4 x 16mm		M4 x 16mm		M6 x 35mm Phillips			M8 x 42mm Bolt
Self-tapping		Screw (86)–4		Screw (87)–8				(71)–4
Screw (79)–10
M8 x 16mm Patch		M8 x 48mm Patch			M10 x 20mm Patch		M10 x 23mm Shoulder
Screw (95)–3			Screw (78)–2		Screw (91)–10			Screw (80)–2
M10 x 62mm Patch Bolt (89)–4					M10 x 78mm Patch Screw (90)–2
					5