Gold's Gym GGBE1658.0 manual See steps 1, 2, and 4. Tighten the M10 Nylon Locknuts

Page 7

2.Attach the Rear Stabilizer (3) to the Frame (1) with two M10 x 90mm Carriage Bolts (40) and two M10 Nylon Locknuts (57). Do not tighten the Nylon Locknuts yet.

3.Attach the Seat (18) and the Seat Bracket (8) to the Frame (1) with two M6 x 80mm Screws (46) and two M6 Washers (53).

4.Attach the Frame (1) to the Front Leg (4) with two M10 x 85mm Bolts (43), two M10 Washers (52), and an M10 Nylon Locknut (57). Do not tighten the Nylon Locknut yet.

Finish attaching the Front Leg (4) to the Frame

(1) with four M4 x 19mm Screws (51).

See steps 1, 2, and 4. Tighten the M10 Nylon Locknuts (57).

2
57
3
40
1
57
3
18

	8
	53	1
		1
53
	46
4
4		1
		57
52
43
	51

7

Image 7

Contents Model No. GGBE1658.0 Serial No QUESTIONS?Call TOLL-FREE Table of Contents Important Precautions Before YOU Begin Assembled DimensionsPart Identification Chart Make Assembly Easier AssemblyLocknuts yet See steps 1, 2, and 4. Tighten the M10 Nylon Locknuts Screws yet Locknut yetBoth sides of the bracket on the Front Leg Repeat this step with the two Short Pad Tubes Both Safety Spotters are at the same height Using the LEG Lever AdjustmentUsing the Curl PAD Adjusting the BackrestRemoving the Curl BAR Adjusting the Weight Rests and the Safety SpottersSpotters are at the same height Exercise Guidelines Cooling Down Muscle ChartStaying Motivated Strength Exercise LOGAerobic Exercise LOG Qty Description Part LIST-Model No. GGBE1658.0Exploded Drawing A-Model No. GGBE1658.0 R0508A Exploded Drawing B-Model No. GGBE1658.0 Limited Warranty Ordering Replacement PartsIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT