5.Apply a portion of the included grease to an M10 x 165mm Bolt (49). Attach the Backrest Post (15) to the Backrest Frames (16) with the Bolt, two M10 Washers (52), and an M10 Nylon Locknut (57). Do not tighten the Nylon
Locknut yet.
Attach the Backrest (19) to the Backrest Frames (16) with four M6 x 40mm Screws (48) and four M6 Washers (53). Do not tighten the
Screws yet.
6.Grease an M10 x 165mm Bolt (49). Attach the Backrest Frames (16) to the Frame (1) with the Bolt, two M10 Washers (52), and an M10 Nylon Locknut (57). Set the end of the Backrest Post
(15)in one of the slots in the Frame. Do not overtighten the Nylon Locknut; the Backrest Frames must pivot easily.
See step 5. Tighten the M10 Nylon Locknut
(57)and the four M6 x 40mm Screws (48). Do not overtighten the Nylon Locknut; the Backrest Post (15) must pivot easily.
7.Attach the Weight Tube (24) to the Leg Lever
(5) with an M8 x 70mm Bolt (44), a 13mm x 16mm Spacer (55), two M8 Washers (54), and an M8 Nylon Locknut (58). Next, press a 25mm Outer Cap (56) onto the end of the Weight Tube.
Apply grease to the barrel of an M10 x 77mm Bolt Set (45). Attach the Leg Lever (5) to the Front Leg (4) with the Bolt Set. Make sure that the barrel of the Bolt Set is inserted through
5
19
Wide End
16
Grease
49 |
|
|
52 |
| 53 |
|
| |
| 52 | 48 |
| 57 |
|
53 |
|
|
48 | 15 |
|
6 |
|
|
Grease |
|
|
49 |
|
|
52 |
|
|
16 | 52 | 15 |
| ||
| 57 | |
|
| |
| 1 | Slot |
|
| |
7 |
|
|
Bracket 
Grease
45
5 | 4 |
| 56 |
45 
58 54 
both sides of the bracket on the Front Leg.
55
24
54
44
8