![](/images/new-backgrounds/1134368/1343689x1.webp)
ASSEMBLY
To hire an authorized service technician to assemble the elliptical exerciser, call
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the
included hex keys, assembly requires a Phillips screwdriver , an adjustable
wrench , and a rubber mallet
.
See the drawings below to identify the small parts needed for assembly. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the key number is the quantity needed for assembly. Note: Some small parts may have been preassembled.
If a part is not in the hardware kit, check to see if it has been preassembled.
M4 x 16mm | M4 x 22mm | M8 Split | M10 Split | M8 Washer | Wave Washer |
Screw | Screw | Washer | Washer |
M8 Jamnut | M8 Nylon | M10 Nylon | Cover Screw | M8 x 16mm Button |
Locknut | Locknut | Screw |
M8 x 25mm Patch | M8 x 45mm Button | M8 x 72mm Button Bolt | ||
Screw | Bolt |
| ||
|
|
|
|
|
|
|
|
|
|
M10 x 75mm Carriage Bolt | M10 x 83mm Button Screw |
M10 x 45mm Button Bolt | M10 x 59mm Bolt Set |
5