FIGURE 10
Step 50. Attach PIVOT PULLEY BRACKETS (32) to RIGHT OBLIQUE FRAME (2) with M8 x 63mm HEX BOLTS (52), M8 WASHERS (64) and M8 LOCKNUTS (69).
Step 51. Attach PULLEYS (76) to PIVOT PULLEY BRACKETS (32) with 3/8” x 2” HEX BOLTS (51), 3/8” WASHERS (62) and 3/8” LOCKNUTS (67).
NOTE: Do not overtighten. PULLEYS must rotate freely.
Step 52. Push 2” SQUARE END PLUGS (71) into ends of BUTTERFLY EXTENSION (25) and attach to RIGHT OBLIQUE FRAME (2) with 3/8” x
Step 53. Push 3/4” BUSHINGS (70) into BUTTERFLY EXTENSION (25) and ADJUSTABLE PLATES (27 RIGHT and 29 LEFT).
Step 54. Insert RIGHT BUTTERFLY ARM (28) through RIGHT ADJUSTABLE PLATE (27), BUTTERFLY EXTENSION (25) and fasten with 5/8” WASHER (65) and 5/8” LOCKNUT (66).
NOTE: Do not overtighten. RIGHT BUTTERFLY ARM must pivot freely.
Step 55. Insert LEFT BUTTERFLY ARM (30) through LEFT ADJUSTABLE PLATE (29), BUTTERFLY EX- TENSION (25) and fasten with 5/8” WASHER (65) and 5/8” LOCKNUT (66).
NOTE: Do not overtighten. LEFT BUTTERFLY ARM must pivot freely.
Step 56. NOTE: Liquid soap applied to HANDLES (26) will help HAND GRIPS (86) slide on easier. Slide HAND GRIPS onto HANDLES.
Step 57. Push 1” ROUND END PLUG (74) into HANDLES (26).
Step 58. Push PLASTIC BUSHINGS “A” (87) into BUTTERFLY ARMS (28 RIGHT and 30 LEFT).
Step 59. Insert HANDLES (26) through PLASTIC BUSHINGS “A” (87) and fasten with M8 x 25mm HEX BOLT (48) and 3/8” BIG WASHER (63) and 5/8” WASHER (65).
Step 60. Push 2” ROUND END PLUG (75) into end of BUTTERFLY ARMS (28 RIGHT and 30 LEFT).
Step 61. Use POP PIN (89) in BUTTERFLY ARMS (28 RIGHT and 30 LEFT) to select desired hole in ADJUSTABLE PLATES (27 RIGHT and 29 LEFT).
24