HOW to USE Resistance and Pace Programs

HOW TO USE RESISTANCE AND PACE

PROGRAMS

Press any button on the console or begin

pedaling to turn on the console.

See step 1 on page 14.

Select one of the resistance and pace

programs.

When the power is

turned on, the

manual mode will

be selected. To

select a resistance

and pace program,

press the Program

button repeatedly until “P 1,” “P 2,” “P 3,” “P 4,”

“P 5,” “P 6,” “P 7,” or “P 8” appears in the right

display.

When a resistance and pace program is selected,

the matrix will show the first ten resistance set-

tings of the program. The left display will show

how long the program will last.

Press the Start button or begin pedaling to

start the program.

Each program is divided into several time seg-

ments of different lengths. One resistance setting

and one pace setting are programmed for each

segment. Note: The same resistance setting

and/or pace setting may be programmed for two or

more consecutive segments.

The resistance

Current Segment

setting for the first

segment will be

shown in the flash-

ing Current

Segment column

of the matrix. (The

pace settings are

not shown in the matrix.) The resistance settings

for the next several segments will be shown in the

columns to the right.

When only three seconds remain in the first seg-

ment of the program, both the Current Segment

column and the column to the right will flash, a

series of tones will sound, and all resistance set- tings will move one column to the left. The resis- tance setting for the second segment will then be shown in the flashing Current Segment column and the resistance of the elliptical exerciser will automatically change to the resistance setting for the second segment. Note: If all of the indicators in the Current Segment column are lit after the resistance settings have moved to the left, the resistance settings will move downward so that only the highest indicators appear in the matrix.

As you exercise,

the Training Zone

bar will help you to

keep your pedaling

pace near the pace

setting for the cur-

rent segment. The

lit indicators in the

bar will show your

actual pace. If an

indicator to the

right of the lit indi-

cators is flashing

(see drawing a),

increase your pace. If an indicator to the left of any lit indicator is flashing (see drawing b), decrease your pace. When no indicator is flash- ing, your pace matches the pace setting for the current segment. Important: The pace settings are intended only to provide motivation. Your actual pace may be slower than the current pace setting. Make sure to exercise at a pace that is comfortable for you.

The program will continue until the resistance set- ting for the last segment is shown in the Current Segment column of the matrix and no time remains in the program.

Note: During the program, you can override the resistance setting, if desired, by pressing the Quick Resistance buttons. However, when the next segment begins, the resistance will automati- cally change if a different resistance setting is pro- grammed for the next segment. If you stop pedal- ing for several seconds, a tone will sound and the program will pause. To restart the program, simply resume pedaling.

Healthrider HRE99940 manual HOW to USE Resistance and Pace Programs