Healthrider HRE99940 manual Not to confuse the Left Pedal Leg with the Right, Way

5. Apply a small amount of grease to the axle on the Left	5
Crank Arm (34).
Identify the Left Pedal Leg (4), which is marked with		Grease	34
an “L” sticker. Slide the Left Pedal Leg onto the axle
on the Left Crank Arm (34). (Note: It may be helpful to		4
use a rubber mallet to tap the Left Pedal Leg on. Do
not to confuse the Left Pedal Leg with the Right
Pedal Leg [not shown].) Attach the Left Pedal Leg
with an M8 x 19mm Patch Screw (111), an M8 Washer
(66), and a Torque Washer (113).
Attach the Right Pedal Leg (not shown) in the same		113
way.
	111	66
See the inset drawing. Identify the Left Pedal (10),
which is marked with an “L” sticker. Attach the Left
Pedal to the Left Pedal Leg (4) with two M6 x 48mm
Flat Head Screws (83). Note: The Left Pedal can be
attached in any of three positions using the three sets
of holes in the Left Pedal Leg.
Attach the Right Pedal (not shown) to the Right		83
Pedal Leg (not shown) in the same way.
		10
		4
6. Hold a Pedal Wheel (28) inside of the bracket on one	6
of the Upper Body Legs (31). Hold the Upper Body
Leg and the Pedal Wheel inside of the bracket on the
Left Pedal Leg (4). Slide a Pedal Leg Cover (33) onto
the long side of an M8 x 63mm Bolt Set (65), and		31
insert the Bolt Set into the Left Pedal Leg, the Upper
Body Leg, and the Pedal Wheel.
Slide a Pedal Leg Cover (33) onto the short side of the			65
M8 x 63mm Bolt Set (65) and tighten it into the long
			33
side of the Bolt Set.
		4
Attach the other Upper Body Leg (not shown) and		33
the other Pedal Wheel (not shown) to the other
side of the elliptical exerciser in the same way.
		65
		28

7